The Difference Between These Two BEAST End Mills

For over 30 years Harvey Tool has been providing specialty carbide end mills and cutting tools to the metalworking industry Find your local cutting tool

The Difference Between These Two BEAST End Mills For full diameter slot cuting I divide the end mill by 120 to find the chip load per tooth Then with three teeth in the tool the total chip

For over 30 years Harvey Tool has been providing specialty carbide end mills and cutting tools to the metalworking industry Find your local cutting tool

slot crash They have spiral fluted, like twist drills, but they cut on the end and both sides Some endmills, called center cutting endmills, can be

Slot drills will have a flute that comes to the middle and an end mill will have clearance in the centre A slot drill has one flute that is slightly longer

slot bet99 A slot mill has two flutes,an endmill usually has four An endmill will always cut out bigger than its diameter,a slot drill should cut to its diameter

Historically, slotting with a 4 flute end mill was a no go! This is down to multiple reasons but mainly due to swarf evacuation and